Skip to main content

New website to track projects

For over a decade profmason.com was a repository of over 200 electronics and robotics projects that I completed between 2004-2014.  In 2016, my web provider disappeared along with all access to the website.  After spending 2 years and 9 months trying to get the domain back from the Panamanian domain squatter who had bulk purchased my domain when it came up at the registry, I have decided to start a new blog to document my projects new and old. 

Comments

  1. neebaltechnologiesblogAugust 10, 2021 at 5:22 AM

    Thanks for suggesting good list. I appreciate your work this is really helpful for everyone. Get more information at cloud migration services. Keep posting such useful information.

    ReplyDelete
  2. pioneerindsysJanuary 4, 2023 at 3:48 AM

    You have published extraordinary article here about my interest of Robotics Integration. It is a genuinely beneficial info for us.

    ReplyDelete

Post a Comment

Popular posts from this blog

Making Nozzles in PVC Pipe fittings from Durhams Rock Hard Water Putty and Graphite plate

A single use rocket nozzle can be made using Water Putty and a graphite plate in a 2" PVC Pipe fitting.  Durhams water putty is a gypsum based putty that exhibits very little shrinkage while drying and is effective as a single use nozzle for motors up to 4" in diameter.  Supplies: 2" PVC Coupling 2" PVC to 3/4" threaded female reducer Water putty 1/4" thick graphite plate ~1"x 1" ( 3/8" ID fender washer can be substituted, but it adds additional complexity) Screwdriver or chopstick for mixing 2 spoons duct tape mixing cup Safety glasses nitrile gloves or equivalent Wear safety glasses and nitrile gloves  Use PVC primer to coat the surface of the reducer and the PVC coupling up to the ridge joint. Use PVC glue to coat the surfaces and then press the PVC reducer into the coupling.  Hold for at least 20 seconds so that the reducer doesn't float out of the coupling.  Cover the small hole in the bottom with duct tape to retain the putty, it i...
Post a Comment
Read more

Characterizing 38mm PVC motors

A previous article described fabricating PVC motors using couplings and endcaps to secure the bulkheads.    Figure 1:  PVC fitting used to retain grains in 2" diameter PVC motor with cork liner.   In an effort to make the motors more flyable, the motors have been redesigned without those elements.   First attempts consisted of drilling a series of 4-6 radial holes and casting the rockite into the holes. This provide insufficient to retain the bulkheads in 4/6 tests, and none of the successful tests exceeded 150 psi.  Figure 2:  Note the forward bulkhead and nozzle bulkheads are extruded out from the pvc.  The next attempt was to cut a 0.25" section 1 1/4" PVC pipe, slit it and glue it into the end of the 1 1/2" pipe.  The Rockite was cast with this lip retaining it.  This was successful in 1/4 tests, but the successful test did hold 380 psi, and the other tests failed at above 300psi.    Here is the data from the...
7 comments
Read more